Gaugemaster PM-2 Seep Point Motor without Switch

Our downloadable 'How To' page giving details of fitting and wiring point motors can be seen here

Seep Point Motors have the advantage of being easy to fix under the baseboard requiring only a small slot to operate the point.

The PM-2 is the standard point motor and does not have a built in changeover switch to operate accessories or change frog polarity (switched motor PM-1 available, if required).

Operating rod is 41mm long and can be cut to the correct length before or after fitting using Xuron 90033 Hard Wire Cutting Shear or similar.

Can be operated by A280-15 SPDT centre bias switch, R044 or PL-26 passing contact switches or PL-17 / PL-18 probe & stud method.

It is recommended that a Capacitor Discharge Unit such as Peco PL-35 or Gaugemaster CDU is used to ensure positive switching of the turnout motor.

PM-1 motor with switch, PM-1BUFFERS pre wired motor and PM-4 motor with switch & latching mechanism also available